Please do not return product to retailer.Por favor, no devuelva el producto al lugar de compra.Veuillez ne pas retourner le produit au détaillant.1--8
10REPLACE SPARK PLUGReplace the spark plug each year to ensurethe engine starts easier and runs better . Setspark plug gap at 0.025 inch (0.6 mm). Ign
11Air Filter CoverIdle Speed ScrewIf you require further assistance or are unsureabout performing this procedure, contact anauthorized service dealer
12TROUBLE CAUSE REMEDYEngine will notstart.1. Engine flooded.2. Fuel tank empty.3. Spark plug not firing.4. Fuel not reachingcarburetor.5. Carburetor
13LIMITED WARRANTYWEED EATER, a divi sion of Husq va r n aConsumer Outdoor Products N.A., Inc.,warrants to the original consumer purchaserthat each ne
14failed due to abuse, neglect, improper mainte-nance, unapproved modifications, or the useof parts not made or approved by the originalequipment manu
2IDENTIFICATION OF SAFETY SYMBOLSW ARNING: This unit can be dangerous! Careless or improperuse can cause serious injury.Trimmer line can throw objects
3IDENTIFICATION OF SAFETY SYMBOLSWhen servicing unit, use only identical replace-ment parts.Store unit indoors in a high, dry place out of the reach o
4S Secure hair above shoulder length. Secure orremove loose clothing or clothing with looselyhanging ties, straps, tassels, etc. They can becau g h t
5ASSEMBLYWARNING: If received assembled,repeat all steps to ensure your unit is properlyassembled and all fasteners are secure.Examine parts for damag
6OPERATIONKNOW YOUR T RIMMERREAD THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.Compare the illustrations with your unit to famil
7FUEL REQUIREMENTSThis engine requires the use of minimum 87octane [R+M]/2 clean gasoline.IMPORTANTUse of alcohol blended fuels (called gasohol orusin
8STARTING A FLOODED ENGINEFlooded engines can be started by placing thechoke lever in the RUN position; then, pull therope to clear the engine of exce
9SWEEPING -- The fanning action of the rotat-ing line can be used for a quick and easyclean up. Keep the line parallel to and abovethe surfaces being
Comments to this Manuals