Weed Eater HD13538 Operator's Manual download pdf (Page 6)

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use

the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard

wrench sizes are listed.

(1) 1/2" wrench

(1) 3/4" wrench

Pliers

Utility knife

Tire pressure gauge

When right or left hand is mentioned in this manual, it means

when you are in the operating position (seated behind the

steering wheel).

TO REMOVE TRACTOR FROM

CARTON

UNPACK CARTON

• Remove all accessible loose parts and parts cartons

from carton.

• Cut along dotted lines on all four panels of carton.

Remove end panels and lay side panels flat.

• Check for any additional loose parts or cartons and

remove.

BEFORE REMOVING TRACTOR FROM

SKID

ATTACH STEERING WHEEL (See Fig. 1)

ASSEMBLE EXTENSION SHAFT AND BOOT

• Slide extension shaft onto lower steering shaft.

• Place tabs of steering boot over tab slots in dash and

push down to secure.

INSTALL STEERING WHEEL

• Position front wheels of the tractor so they are pointing

straight forward.

• Remove steering wheel adapter from steering wheel

and slide adapter onto steering shaft extension.

• Position steering wheel so cross bars are horizontal

(left to right) and slide inside boot and onto adapter.

• Assemble large flat washer, 5/16 lock washer, 5/16 hex

bolt and tighten securely.

• Snap steering wheel insert into center of steering

wheel.

• Remove protective materials from tractor hood and

grill.

IMPORTANT: CHECK FOR AND REMOVEANY STAPLES IN

SKID THAT MAY PUNCTURETIRES WHERE TRACTOR IS TO

ROLL OFF SKID.

/ _:_,...,,--_INSE RT

_--_:.,_,-._ 5116 HEX BOLT

_ 5/16 LOC K

_i WASHER

STEERING/- )---

WHEEL

LOWER

STEERING

SHAFT-

SHAFT

5- - __ TAB

"-_. -. _ / ,_'_ SLOTS

FIG. 1

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment bolt.

• Remove adjustment bolt, lock washer and flat washer

securing seat to cardboard packing and set aside for

assembly of seat to tractor.

• Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

• Place seat on seat pan so head of shoulder bolt is

positioned over large slotted hole in pan.

• Push down on seat to engage shoulder bolt in slot and

pull seat towards rear of tractor.

• Pivot seat and pan forward and assemble adjust-

ment bolt, Iockwasher and flat washer loosely. Do not

tighten

• Lower seat into operating position and sit on seat.

• Slide seat until a comfortable position is reached

which allows you to press clutch/brake pedal all the

way down.

• Get off seat without moving its adjusted position.

• Raise seat and tighten adjustment bolt securely.

1 2 3 4 5 6 7 8 9 10 11 ... 29 30

Comments to this Manuals

No comments

Weed Eater HD13538 Operator's Manual Page 6

Comments to this Manuals

Related products and manuals for Lawnmowers Weed Eater HD13538