Weed-eater 952711899 User Manual download pdf (Page 9)

9

Battery Pack 545124416

Charger 545124415

REPLACEMENT PART PART NUMBER

USER REPLACEABLE SERVICE PARTS

STORAGE

WARNING: Perform the following

steps after each use.

S Stop the unit and remove the battery pack

when not in use.

S Carry the unit with motor stopped.

S Store the unit so the blades cannot cause

injury.

S Store unit indoors in a high, dry place out of

the reach of children.

S Store unit with all guards in place. Position

unit so that any sharp object cannot acci-

dentally cause injury.

BATTERY DISPOSAL

WARNING: Remove the battery pack

from the hedge trimmer . Cover the terminals

with heavy duty adhesive tape. Do not attempt

to destroy or disassemble battery pack or re-

move any of its components. Nickel--cadmium

batteries must be recycled or disposed of prop-

erly. Also, never touch both terminals with metal

objects and/or body parts to avoid short circuit-

ing the battery pa ck. Keep away from children.

Failure to comply with these warnings could re-

sult in fire or serious personal injury.

S To preserve natural resources, please re-

cycle or dispose of batteries properly.

S This product contains nickel--cadmium batter-

ies. Local, state or federal laws may prohibit

disposal of nickel--cadmium batteries in ordi-

nary trash.

S Consult your local waste authority for infor-

mation regarding available recycling and/or

disposal options.

TROUBLE CAUSE REMEDY

Unit fails to

operate

1. Remove battery and check connectors.

Replace battery.

2. Charge battery pack.

3. Remove debris.

Cutting blades

stop under a

load or do not

move when

trigger switch

is pressed

1. Cut at a slower pace.

2. Clean debris from blades.

3. Charge battery pack.

4. Co ntac t your authorized service dealer.

Poor cutting

quality

1. Ensure the product is being used

correct ly .

2. Clean debris from blades.

3. Contact your authorized service dealer.

Excessive

vibration

1. Contact yo ur authorized service dealer.

TROUBLESHOOTING TAB LE

1. Damaged blades.

1. Unit is being used

incorrectly.

2. Blades clogged with

debris.

3. Damaged blades.

1. Forcing blade into

material being cut.

2. Blades clogged with

debris.

3. Battery needs charging.

4. None of the above

1. Battery not attached to

unit correctly.

2. Battery needs charging.

3. Debris stopping blade.

WARNING: Always stop unit and remove battery pack before performing all of the

recommended remedies below except remedies that require unit to be operating.

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments