Weed Eater 2600 Series Instruction Manual download pdf (Page 10)

Installing the cutter guard

Cutting tool Cutter guard

Tool/guard combinations for the BCM2600 / BCM3300 / BCM4300

4-tooth star blade: Part no. 362 224 140 Part no. 351 504 101

Outside diameter: 230 mm (9"), arbour: 25.4 mm (1")

2-line trimmer head Part no. 351 502 030 Part no. 351 504 101

15 m Part no. 369 224 670 and

120 m Part no. 369 224 672 Part no. 351 504 102

Install the guard extension

Mounting the cutter guard

- Hook the hood (A/5) by the cutout (A/1) on the lug (A/2).

- Insert and tighten bolt (A/3) and nut (A/4).

Important: Safety regulations and your own safety make

it imperative to use the right cutter guard with a given

cutting tool!

Warning: Use only the cutting tools shown here! It is not

permitted to use other cutting tools as this can increase dan-

ger of accidents and cause damage to the equipment!

Mounting the guard extension for use with trimmer head.

- See above for installation of the cutter guard.

- Attach the guard extension (B/6) supplied with the brushcut-

ter to the upper part of the cutter guard (A/5), bending it to

ﬁ t the contour of the guard.

- Attach the trimmer line knife (B/7) to the guard extension

(B/8) with the bolt (B/6).

Note: If the trimmer line has been extended (see “Adjusting

the line”) the trimmer line knife automatically cuts the line

ends to the same length during use.

Cutting tool Cutter guard

Tool/guard combinations for the BCM2310 / BCM2610 / BCM3310

2-line trimmer head Part no. 351 502 030 Part no. 351 504 101

15 m Part no. 369 224 670 and

120 m Part no. 369 224 672 Part no. 351 504 102

Install the guard extension

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Weed Eater 2600 Series Instruction Manual Page 10