Weed Eater 2600 Series Instruction Manual download pdf (Page 15)

Cold start

- Prime the fuel pump (G/5) by pressing it several times until

you can see fuel in the pump.

- Actuate the half-throttle lock by depressing the safety lock

(F/3), pressing in the throttle (F/1) and moving the combi-

nation switch (F/2) into the START position. Then release

throttle (F/1) and then the combination switch (F/2).

- Turn the choke lever (G/4) to the CHOKE (closed) posi-

tion.

- Hold the brushcutter with one hand as shown in Fig. E on

page 14.

- Pull the starter cable slowly until you feel resistance (piston

is just before top dead centre).

- Now pull quickly and forcefully until you hear the ﬁ rst

audible ignition (the engine will start brieﬂ y).

- Do not pull out the whole starter cable to its full extent and

do not let the starter handle jump back, but let it slowly

automatically rewind itself.

- Turn the choke lever (G/4) to the RUN (open) position and

pull the starting handle again until the engine runs.

- Once the engine has started, press the throttle (F/1) all the

way and release it again immediately. The half-throttle catch

will come out and the engine will idle.

Warmstart

- If the engine is warmed up do not prime the fuel pump.

- Move the combination switch (F/2) to the “I” position.

- Do not turn the choke switch to the CHOKE (closed) posi-

tion, but to RUN.

Stop engine

Move the combination switch (F/2) to the “O” position.

Important: The cutting tool must not rotate when the engine

is idling! If it does, adjust the idle speed.

- The appropriate cutting tool must be mounted.

- Make sure the air ﬁ lter is clean.

- Let the engine run warm.

- Do not operate the throttle (F/1).

- Unscrew the adjustment screw (H/6) no more than 1/8 turn

(counter-clockwise).

- Repeat the procedure if the cutting tool still rotates during

idling.

If the cutting tool does not stop, do NOT work with the brushcut-

ter. Take it to a MAKITA service centre!

Idle adjustment

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

Weed Eater 2600 Series Instruction Manual Page 15