FS 45, FS 46
English
16
N Place the friction liner in the loop
handle.
N Fit the loop handle (1) on the drive
tube at distance (A) of about 20 cm
(8 in.) from the control handle (2).
N Slide the spacer (3) – if supplied –
into the loop handle as far as
possible.
N Insert the screw (4) through the loop
handle and the spacer until the
screw head locates in the loop
handle's hexagon recess.
N Fit the washer (5).
N Fit the wingnut (6) and tighten it
down firmly.
Adjusting loop handle to most
comfortable position
N Loosen the wingnut (6).
N Move the loop handle (1) along the
drive tube as required.
N Tighten down the wingnut (6) firmly.
N Push the deflector (1) over the
clamp (2) as far as stop.
N Insert the nut (3) in the hex recess in
the deflector – make sure the holes
line up.
N Insert the screw (4) and tighten it
down firmly.
Mounting the Loop Handle
Mounting the Deflector
Comments to this Manuals